Polyglycerol based coatings to reduce non-specific protein adsorption in sample vials and on SPR sensors

Coatings based on dendritic polyglycerol (dPG) were investigated for their use to control nonspecific protein adsorption in an assay targeted to analyze concentrations of a specific protein. We demonstrate that coating of the sample vial with dPG can significantly increase the recovery of an antibody after incubation. First, we determine the concentration dependent loss of an antibody due to nonspecific adsorption to glass via quartz crystal microbalance (QCM). Complementary to the QCM measurements, we applied the same antibody as analyte in an surface plasmon resonance (SPR) assay to determine the loss of analyte due to nonspecific adsorption to the sample vial. For this purpose, we used two different coatings based on dPG. For the first coating, which served as a matrix for the SPR sensor, carboxyl groups were incorporated into dPG as well as a dithiolane moiety enabling covalent immobilization to the gold sensor surface. This SPR-matrix exhibited excellent protein resistant properties and allowed the immobilization of amyloid peptides via amide bond formation. The second coating which was intended to prevent nonspecific adsorption to glass vials comprised a silyl moiety that allowed covalent grafting to glass. For demonstrating the impact of the vial coating on the accuracy of an SPR assay, we immobilized amyloid beta (Aβ) 1-40 and used an anti-Aβ 1-40 antibody as analyte. Alternate injection of analyte into the flow cell of the SPR device from uncoated and coated vials, respectively gave us the relative signal loss (1 − RU_uncoated/RU_coated) caused by the nonspecific adsorption. We found that the relative signal loss increases with decreasing analyte concentration. The SPR data correlate well with concentration dependent non-specific adsorption experiments of the analyte to glass surfaces performed with QCM. Our measurements show that rendering both the sample vial and the sensor surface is crucial for accurate results in protein assays.     

Theoretical insight of nitric oxide adsorption on neutral and charged Pdn (n = 1–5) clusters

Density functional theory (DFT) calculations within the framework of generalized gradient approximation have been used to systematically investigate the adsorption of nitric oxide (NO) molecule on neutral, cationic, and anionic Pd_n (n = 1–5) clusters. NO coordinate to one Pd atom of the cluster by the end‐on mode, where the tilted end‐on structure is more favorable due to the additional electron in the π* orbital. On the contrary, in the neutral and cationic Pd₂ system, NO coordinates to the bridge site of cluster preferably by the side‐on mode. Charge transfer between Pd clusters and NO molecule and the corresponding weakening of N? O bond is an essential factor for the adsorption. The N? O stretching frequency follow the order of cationic > neutral > anionic. Binding energy of NO on anionic clusters is found to be greater than those of neutral and cationic clusters. © 2015 Wiley Periodicals, Inc.     

活性炭孔隙结构对催化氧化脱除单质汞的影响

研究活性炭在硫化氢存在条件下催化氧化脱除煤气中单质汞的吸附机理和探讨提高其吸附能力的方法,在模拟煤气气氛下对3种活性炭和一种活性焦进行汞的吸附性能实验,并进一步分析活性炭(焦)的孔隙结构。用BET方程处理N₂等温吸附数据,计算比表面积;用HK法进行微孔分析;用BJH法计算中孔孔径分布。结果表明,硫化氢被催化氧化后,生成吸附在活性炭孔壁上的活性硫促进了对汞的吸附;随着活性炭微孔和中孔体积的增大,活性炭对汞的吸附能力得到提高。     

Ru添加对Co/SiO2费托合成催化剂性能的影响

用初湿含浸法制备了不同Ru添加量的Co/SiO₂模型催化剂,然后进行N₂物理吸附、XRD、H₂-TPD、DRIFTS等表征和微分固定床费托(F-T)反应评价。F-T反应结果表明,催化剂中添加Ru后,CO转化率显著提高,TOF值增大,CO₂和CH₄选择性降低,烯/烷比(O/P)降低。FT-IR表征说明,催化剂添加Ru后Co-O键的强度减弱,相对应的H₂-TPR也表明,催化剂的还原度得到显著提高。还原后的催化剂XRD结果进一步证实,加入Ru后,催化剂无钴氧化物被检出,并且当Ru添加量为0.5%(质量分数)时催化剂中金属钴主要以六方密堆(hcp)形式存在。CO-DRIFTS结果显示,Ru的加入使CO的吸收峰发生红移,即Ru促进了CO的解离。H₂-TPD结果则表明,随着Ru添加量的增加,催化剂表面CO_ads/Co_s和CO^*/Co_s增大,这是CH₄选择性降低的主要原因。     

[BIm]Cl/CuCl离子液体脱除MTBE中硫醇机制及性能研究

以N-丁基咪唑、HCl和CuCl为原料两步法合成了离子液体[BIm]Cl/CuCl,并用傅里叶变换红外光谱FT-IR和傅里叶变换离子回旋共振质谱FT-ICR MS对其结构进行表征。采用差热扫描量热仪DSC、FT-IR以及紫外可见光谱UV-vis对吸附硫醇的[BIm]Cl/CuCl进行分析,讨论了[BIm]Cl/CuCl吸附硫醇的作用机制。以[BIm]Cl/CuCl为吸附剂,采用吸附蒸馏工艺脱除MTBE中的硫化物,MTBE硫含量可降低至5 μg/g以下,吸附剂进行多次循环使用且脱硫效果无明显降低。     

溶剂极性控制下的煤抽余物吸附甲烷能力研究

基于原煤和有机溶剂抽余物的等温吸附实验结果,对比分析溶剂极性与其煤抽余物吸附甲烷能力变化关系,探讨抽提溶剂极性差异对煤抽余物吸附甲烷能力控制的地球化学机理。结果表明,煤溶剂抽余物等温吸附甲烷曲线都遵循Langmuir方程,且二硫化碳(CS₂)和苯(C₆H₆)溶剂抽提作用增大了煤吸附甲烷量,四氢呋喃(THF)和丙酮溶剂抽提作用减小了煤吸附甲烷量。实验发现,煤抽余物吸附甲烷能力变化与抽提溶剂极性成负相关关系,该现象可用相似相容原理解释:CS₂和C₆H₆溶剂极性较弱,抽提出较多具有非极性结构(-CH₃和-CH₂-)的烷烃和芳烃,为甲烷在煤表面吸附增多了吸附位而增强了抽余物吸附甲烷能力,THF和丙酮溶剂极性较强,抽提出较多具有极性结构(-CHO、-OH、和-COOH)的非烃和沥青质,减少了吸附位而降低煤抽余物的甲烷吸附能力。     

水对Ni/MgAlO催化丙酮加氢的影响

研究了H2O对Ni/MgAlO催化剂上丙酮加氢为异丙醇的催化反应的影响。结果发现,在丙酮中添加少量H2O可提高丙酮转化率,但超过5%的H2O量则会显著降低催化剂活性。吸附量热结果表明,催化剂表面吸附少量H2O会明显降低异丙醇的吸附热,但对丙酮吸附热的影响较小,这也许是反应体系中少量的H2O能促进丙酮加氢活性的原因之一。当催化剂表面吸附较多H2O后,丙酮、异丙醇和H2的吸附热都降低了,因此反而抑制了丙酮的加氢反应。此外,红外光谱结果表明,预吸附水抑制了催化剂表面异丙醇脱氢生成丙酮,并抑制吸附的丙酮在表面生成烯醇盐或异丙叉丙酮等物种,这也许是少量水能促进丙酮加氢生成异丙醇的另一个重要原因。     

Trace analysis of Pt (IV) metal ions in roadside soil and water samples by Fe3O4/graphene/polypyrrole nanocomposite as a solid-phase extraction sorbent followed by atomic absorption spectrometry

A novel Fe₃O₄/graphene/polypyrrole nanocomposite has been successfully synthesised via a simple chemical method and applied as a new magnetic solid-phase extraction (MSPE) sorbent for the separation and pre-concentration of trace amounts of Pt (IV) in environmental samples followed by flame atomic absorption spectrometric (FAAS) detection. The nanocomposite has been characterised by scanning electron microscopy (SEM), transmission electron microscopy (TEM) and Fourier transform infrared (FTIR) spectroscopy. Seven important parameters, affecting the extraction efficiency of Pt (IV), including pH, adsorption time, desorption solvent type and concentration, desorption time, elution volume and sample volume, were investigated. Under the optimised conditions, the calibration graph was linear in the range of 50–1500 μg L^?1 (R = 0.993). The detection limit and pre-concentration factor (PF) for Pt (IV) were found to be 16 μg L^?1 and 112.5, respectively. Under the optimised solid-phase extraction (SPE) conditions, the adsorption isotherm and the adsorption capacity of the nanocomposite for Pt (IV) were studied. Pt (IV) adsorption equilibrium data were fitted well to the Langmuir isotherm and the maximum adsorption capacity of the magnetic sorbent was calculated from the Langmuir isotherm model as 416.7 mg g^?1. The precision of the method was studied as intraday and interday variations. A relative standard deviation percentage (RSD%) value less than 3.0 indicates that the method is precise. Also, the accuracy of the method was tested by the analysis of the standard reference material (NIST SRM 2556) and by recovery measurements on spiked real samples. It was also shown that the optimised method was suitable for the analysis of trace amounts of Pt (IV) in roadside soil, tap water and wastewater samples.     

Adsorption of Propene on Neutral Gold Clusters in the Gas Phase

The adsorption of propene on neutral gold clusters is investigated in a collision cell under a few collision conditions. The adsorption reaction is studied by pressure‐dependent kinetic measurements and delayed unimolecular dissociation of the excited Au_n?propene complexes. The cluster size (n=9–25) and temperature (T=90–300 K) dependence of the propene adsorption is analyzed. Strong size dependences of the absorption reaction are observed; a larger propene adsorption probability was found for gold clusters composed of an even number of atoms. Propene binding energies are estimated by comparison of the temperature‐dependent unimolecular dissociation rates with rates obtained by using statistical RRKM modeling. The Au_n–propene binding energies decrease non‐monotonously with cluster size and are in the range of 1.2–0.85 eV for n=9–25. Finally, the bonding of C₃H₆ on Au_n is qualitatively described and similarities with the absorption of CO molecules on gold clusters are discussed.